Chapter 2: Unit Installation
Ethernet Status -
These LEDs correspond to the status of the Ethernet
connection. See
Frequently Asked Questions on page 80
for more
information.
USB Recovery
- This port can be used to perform a firmware recovery
and configuration reset. See
Firmware Recovery and Configuration
Reset on page 78
for more information.
Warning!
The USB Recovery port provides a limited amount of
current which is sufficient only to power a USB flash drive. Do not
connect any other type of device to this port. The USB flash drive
should be fully USB 2.0 compliant.
T1/E1 Port(s)
- These ports are used for connecting T1 or E1 cables.
See
RJ45 T1/E1 Port Connector on page 86
for more information.
T1/E1 Status
- These LEDs correspond to the status of the T1/E1
ports. See
Frequently Asked Questions on page 80
for more infor-
mation.
Reset Switch (G400/G800 only)
- This recessed switch is used to
restart the Gateway Series appliance or reset its GUI password. See
Frequently Asked Questions on page 80
for more information.
Digium, Inc.
Page 22
