Chapter 2: Unit Installation
Configuration Server
- If
Obtain an IP Address via DHCP
is enabled
on an Interface tab and
Get Config Server from Option 66 via DHCP
is
disabled, the path to the configuration server may be statically defined
using this option. The
Reload Remote Config on Reboot
option must be
enabled in order to activate this feature. Refer to the note on
page 38
for
proper syntax when specifying the path and configuration database file.
The
Interface
options for the G400 and G800 models are specified below.
Enable Untagged Traffic
- If disabled, this option will prevent traffic
which is not VLAN tagged from passing over this interface.
Obtain an IP Address via DHCP
- If a DHCP server exists on the
same network as the Gateway Series appliance, this feature may be
enabled for the IP address to be dynamically assigned via DHCP.
Note:
It is recommended that this feature be disabled if the DHCP
server is not configured to always provide the same IP address
based on MAC address. If this is the case, the Gateway Series
appliance’s network settings should be manually configured. The
MAC addresses of the Gateway Series appliance are printed on a
label on the back of the unit.
System IP Address
- If
Obtain an IP Address via DHCP
is disabled,
specify the static IP address for the Gateway Series appliance.
Note:
If a static IP address is assigned using this feature, the
Gateway Series appliance will immediately be unresponsive from
its old IP address. It may take up to 15 seconds for the new IP
address to be assigned and functional. The new IP address of the
Gateway Series appliance must be entered into the browser and
Digium, Inc.
Page 43
