-30-
Authentication
To adjust the authentication settings, enter your login as a super user,
and change your password.
Super user login
Enter the login name of the super user. The initial value is “super”.
All characters are in lower case.
Super user password
Enter the current password for the super user. This initial value is “pass”.
All characters are in lower case.
New super user password
Enter the new password for the super user.
New password (confirm)
Re-type the new password for the super user for confirmation.
To close the window and accept the changes, press the “OK” button;
otherwise press the “Cancel” button.
9.2
Configuration Setup via Serial Console
For using serial terminal, the IP-KVM has a serial line interface (host side). This
connector is compliant with the RS-232 serial line standard. The serial line has to
be configured with the parameters given in Table below.
Parameter Value
Bits/second 115200
Data bits
8
Parity No
Stop bits
1
Flow Control
None
When configuring with a serial terminal, e.g., Hyper Terminal, reset the IP-KVM
and immediately press the “ESC” key. You will see some device information, and
a “=>” prompt. Enter “config”, press “Enter” key and wait for a few seconds for the
configuration questions to appear.
As you proceed, the following questions will appear on the screen. To accept the
default values shown in square brackets below, press “Enter” key.
IP auto configuration: None
IP address: [192.168.0.70]
Net mask: [255.255.255.0]
Gateway: [0.0.0.0] -- (0.0.0.0 for none)
