Digitronic
Digital Cam Switch Unit
Automationsanlagen GmbH
CamCon DC16
7. Operation of the CamCon
.
7.1. The main menu
The programming always starts at the main menu. No
matter in which state of programming you are, you can
always reach the main menu by pressing the
key
(several times, if necessary).
By pressing the corresponding number or by selection
with keys
and
and a verification with the
key,
you can enter the submenus.
7.2. The standard display
You reach the submenu for the display for normal operation of the cam controller via the main menu
point
"Visual mode"
or by pressing the
key (at the main menu).
In the display menu, the active program number, the
relative speed as a bar (e.g. for an analog speed output)
and the current actual position, respectively the absolute
speed (with higher rotational numbers), are displayed.If
the measuring system is put into a slow motion the
respective actual position is shown on the display. With
increasing rotation velocity the device switches at a
defined point (5%) to a display showing the current speed
in the desired representation; a negative direction in the
rotation is shown through a negative sign in front of the
displayed value.
The configuration of the speed display is done in the system setting menu. Here you can e.g. disable
the automatic change of the display, by selecting a certain display type (see chapter "7.4.3. The speed
adjustment" on page 56).
7.2.1. Changing the display
If you want to receive status information of in- and outputs during operation, you can switch through the
several status displays, using keys
and
. The display then shows an outline of operation for
inputs and outputs:
Output display
Input display
As soon as an in- or output activates, its field on the display turns black.
In the lower righthand corner of the display, you can see the current position or the absolute speed at a
faster movement.
Version: Aug. 04
Page: 29
