DigiTech iPB-10, Owner'S Manual

Page: 71 / 74

71
If you experience a problem with the iPB-10 hardware, you can try performing the factory hard reset procedure listed below.
iPad Connected
1. Turn off the power to the iPB-10 processor by pressing the
Power Switch
on the back panel.
2. Press and hold
Footswitch A
then power on the iPB-10 – keep
Footswitch A
held down until you see ‘
F r
’ in the LED
display, then release.
3. Press and hold
Footswitch A
again until the display reads ‘
rS
’, then release.
4. Wait for the processor to go through its sequence. When the reset is complete, the iPad will resync all presets with the
iPB-10 hardware.
5. Once preset sync is complete, the iPB-10 Expression Pedal will need calibration. Follow the
On-Screen Instructions
to calibrate the Expression Pedal.
iPad Disconnected
1. Turn off the power to the iPB-10 processor by pressing the
Power Switch
on the back panel.
2. Press and hold
Footswitch A
then power on the iPB-10 – keep
Footswitch A
held down until you see ‘
F r
’ in the LED
display, then release.
3. Press and hold
Footswitch A
again until the display reads ‘
rS
’, then release.
4. After a few moments, ‘
Td
’ will appear in the display and the Footswitch 5 LED will begin flashing. Rock the
Expression Pedal
completely forward (toe down) then press
Footswitch 5
.
5. When ‘
tU
’ appears in the display, rock the
Expression Pedal
completely back (toe up) and press
Footswitch 5
.
6. A numeric value will now appear in the LED display indicating the Expression Pedal V-Switch sensitivity. Press firmly on
the
Expression Pedal Toe
. Use the
Bank Up
and
Bank Down Footswitches
to fine tune the V-Switch sensitivity.
7. Press
Footswitch 5
to complete the procedure.
8. Once the iPad is reconnected, it will sync and reassign all factory tones back to the iPB-10 footswitches.
Factory Hard Reset Factory Hard Reset
WARNING!
Performing the factory hard reset procedure will restore the iPB-10 tones to their
factory state. After performing a factory hard reset, you can connect the iPad and launch the
iPB-Nexus app to restore your previous settings.