20
Amp Loop
These 1/4” send and return jacks allow you to connect an
external preamp or amplifier and use the tone from these
components instead of the internal amplifiers of the iPB-10.
iPB-10 Rear Panel
iPB-10 Rear Panel
Stomp Loop
These 1/4” send and return jacks
allow you to insert an external
stompbox effect pedal (or chain
of effects) into the iPB-10 signal
path.
Amp Loop Ground Lift Switch
This switch can be enabled to help prevent unwanted
hum or buzz caused by ground loops between the iPB-10
and an externally connected amplifier or preamp.
NOTE:
Status messages will be displayed if the AMP or STOMP footswitches are pressed and the Amp or Stomp Loop
modules are not used in the current preset Tone (unavailable), or if nothing is connected to these jacks (not connected).
Summary of Contents for iPB-10
Page 1: ...OWNER S MANUAL...
