D H C P
The Dynamic Host Configuration Protocol (DHCP) is a network configuration protocol that allows a device to configure
automatically according to the network it is connected to.
If your network supports DHCP, and your MEGAPIX camera is setup as DHCP; then once you search for your camera
using IP Finder, the search results will display your MEGAPIX camera with already set network settings that
correspond to your network requirements.
S t a t i c
Static IP addresses are recommended when using a network that does not support DHCP. If Static is selected, then
you must manually enter all the network settings for your MEGAPIX camera that would correspond with your network.
Static IP addresses are recommended if you want to setup your device to be accessed externally via the internet. For
each setup of the camera to a static IP address, it is recommended that you first setup the camera to DHCP, allow it to
configure itself according to your network, and then change the settings to a static IP address.
1.
To set your MEGAPIX camera to static, highlight the desired device from the search results list, and click on
Configuration. In the new setup window, make sure static is selected.
2.
Enter the following information:
IP Address
,
Netmask
,
Gateway
,
Preferred DNS
.
3.
Click
Apply
and
System Reboot
to save all changes.
D D N S
Dynamic Domain Server is a feature that allows you to use a URL instead of an IP address to access your MEGAPIX
camera. The feature is optional, for it may require subscription and payment.
1.
To use the DDNS feature, check the box next to
Use DDNS
.
2.
Select the server you wish to use. *Some servers may require subscription and payment.
3.
Enter the desired
Hostname
.
4.
If applicable, enter the
User ID
and
Password
.
5.
Click
Apply
and
System
Reboot
to save all changes.
IP FINDER SOFTWARE*
21
