How to access the Camera’s OSD Menus
1
To access each sensor’s OSD menus select one of the following options :
The camera has four (4) BNC outputs, each supporting UTC (Up the Coax) communication.
When the camera is connected to a DVR supporting UTC communication, you can access
the camera’s OSD menu directly from the DVR.
2
The camera supports RS485 communication, allowing to control the camera remotely.
3
In the camera’s external control board, there is a switch next to the joystick controller.
The switch determins which of the three (3) sensor will be displayed in the test BNC output.
When selected, the selected sensor’s display will appear in the Test video out for 60 sec.
The camera has three separate sensors, each with its own OSD menu and settings.
When adjusting the camera’s settings, each lens/sensor will have their own set of values and settings
and will be set separately.
In addition, the camera offers a 4 BNC output of a combined 180˚view as a single camera output. This
output has an additional Panoramic OSD menu with special settings including sticthing and motion
and patrol setup.
UP
R
D
L
NOTE :
Option 3 does not support access to the fourth Panoramic OSD menu. Please use UTC or RS485
cabling to access those options.