11
um-dve10vr2 (g) 4/17
INSTALLATIoN (CoNTINUED)
There are three mounting holes in the back of the display for attachment of a ball mounting
plate. Take care not to strip the screw holes or over tighten. (Figure 4) it is recommended the
remaining ball be mounted on a flat surface. because of various surface substrates where
the display is mounted, the installer provides the screws to mount the other ball.
• Note the location of the three mounting holes on a ball mounting plate (Figure 3)
• with three (3) m4 x 10 counter-sunk stainless screws (Figure 2) attach mounting plate to
the back of the dve10vr2 (Figure 1)
• mount second ball mounting plate on surface where the display is to be installed
• insert each ball into the ram arm
• Lightly tighten the arm around the balls using the T-knob on the arm (Figure 1, 3)
• adjust the display to the viewing preference, and
• Tighten the T-knob to hold the display in position.
PANEL MoUNT
panel mount installation should be specified at time of or-
der; the ball-and-socket mount system will not be included
in shipping box. (Figure 4) There are four tapped mounting
holes on four corners of the display’s rear panel. a mount-
ing hardware packet is included with product accessories in
the shipping box. This packet includes four (4) m4 stainless
steel threaded studs, 7.6cm (3” long), four (4) Nylock self-
locking nuts and four (4) flat washers.
installer should refer to product drawings on dse’s web
site,
www.digitalsys.com
for exact measurements of the
display’s rear panel. These should be helpful when installer
cuts the required installation opening.
FIGURE 4
FLUSh MoUNT wITh oPTIoNAL bEzEL
with Flush mount bezel, the display may be mounted flush with mounting surface; this
should be specified at time of order as ball-and-socket mount system or any mounting hard-
ware will not be included in the shipping box. installer needs to supply screws for this instal-
lation.
installer should refer to product drawings on dse’s web site,
www.digitalsys.com
for exact
measurements of display. Note: Locations of milled holes in Flush mount bezel. drill cor-
responding holes into the substrate where display is to be mounted.
CAuTION!
enclosure is aluminum; do not over tighten screws or strip screw holes.
do not block or constrain the pressure equalizer valve.
PRESSURE EQUALIzER VALVE
There is a pressure equalizer valve on the chassis. (Figure 5)
in the final installation, do not block or constrain this valve.
FIGURE 5
