Using the projector
Digital Projection Ltd. Titan Laser WUXGA
Setup
Infrared Remote
IR Code
IR Code Reset
Memory
OSD Settings
On
0
Trigger-2
Off
Trigger-1
Off
Standby Period
Instant Startup
Off
30 Min.
EDID Mode
Trigger-1
and
Trigger-2
are not available with
input HDMI 3 or HDMI 4. If
you turn the remote
control off, you can only
turn it back on again from
the control panel or via the
Projector Controller
application.
The
Projector Controller
software is available for
download from the Digital
Projection website, free of
charge.
A wired remote control will
also be disabled if
Infrared Remote
is set to
Off
.
l
Trigger1
and
Trigger 2
Choose from
Screen, 5:4, 4:3, 16:10, 16:9, 1.88, 2.35, TheaterScope, Source, Unscaled
or
RS232
to
determine what will cause each trigger output to activate.
l
Infrared Remote
Set to
Off
if you wish to disable the remote control.
l
IR Code
The projector and the remote control need a matching IR code: a two-digit number between
00
and
99
.
The default IR code is
00
. This is also a master code, which, if assigned to a remote, will work regardless
of the value assigned to the projector.
l
To assign an IR code for the projector:
Select IR code. Use the UP and DOWN arrow buttons to
change the values.
l
To assign an IR code for the remote
, press and hold the
ADDR
button on the remote until the
On indicator starts flashing. Release the
ADDR
button and while the indicator is still flashing,
enter a two digit address using the numeric input buttons. The indicator will flash three times
quickly to confirm the change.
l
IR Code Reset
Use this command to unassign an IR code from the projector. This will revert the
IR Code
value to 00.
To unassign an IR code from the remote control
, press and hold
ALT
and
ADDR
simultaneously until
the On indicator flashes to confirm the change.
l
OSD Settings
Access this submenu to adjust the appearance and position of the on-screen display.
l
Memory
Access this submenu to save up to four presets containing custom combinations of image settings, or to recall a saved preset.
l
Instant Startup
When
ON
only the Laser will be turned off when the Power off command is given. A subsequent Power On will turn on the laser giving an apparent very fast
power on.
l
Standby Period
Used with Instant Startup. If Instant Startup in
ON
and the projector is powered down then the projector will go to Standby after the selected “Standby Period”
30 minutes, 60 minutes, 90 minutes.
l
EDID Mode
Access this submenu to set the frame rate and display resolution for each input type..
Highlight the
UP
arrow at the top of the page and press
ENTER/OK
to go back to the first
Setup
menu page. Highlight the
DOWN
arrow at the bottom of the page
and press
ENTER/OK
to navigate to the third Setup menu page.
Operating Guide
Rev A January 2019
page 79
Notes