Digital Projection
Titan Laser Series
Rev A January 2019
Page 19
Important Information
Inserting a new lens
Before changing the lens, always make sure the projector is switched off and fully
disconnected from its power supply.
Always allow the projector to cool for five minutes before disconnecting the power or
moving the projector.
The lens release lever should always be set to the locked position to prevent the lens
from falling out.
Do not place the projector with its front panel down on a surface, as this may damage
the lens or the lens release lever.
Avoid touching the surface of the lens as this may result in image impairment.
Take care to preserve the original lens packaging and protective caps for future use.
1. Turn the lens release lever
clockwise so that it is pointing
upwards, to open the lock fully.
1
2. Remove the rear lens cap from
the lens.
3. Insert the lens into the lens
aperture, making sure that
the plug on the zoom drive
mechanism lines up with the
socket on the front of the
projector, then push the lens in
firmly as far as it will go.
2
4. Turn the lens release lever anti-
clockwise to the mid-position.
3
3
1
2