Digital Projection LIGHTNING 10sx, User Manual

Page: 42 / 151

Turning On the Lamp
The lamp should light up within 25 seconds of the projector being turned on. If it
has not lit, the bottom red LED at the front of the case will glow constantly and the
projector should be turned off and back on again.
Never look into the lamp housing or the lens, or attempt to remove the lamp from
its housing when the projector is on.
Picture Display
The picture display can be controlled using the PIC MUTE button on the remote
control. When muted the screen goes blank (with the shutter option included, PIC
MUTE will provide additional blackout by removing any stray light that may fall
onto the screen). Changing the lamp power when the picture is muted will cause the
image to be displayed.
When unmuted the video image is displayed on screen and the lamp is set to either
HIGH or LOW depending on the last selection made with the lamp power buttons.
The Picture Display can be set in the User Preferences menu for the next time the
projector is switched on (see System Operation, C—29).
IMAGE CONTROL
The image parameters determine how a picture looks on screen and are adjusted by
using the remote control or the on-screen Modify menu. Adjustable parameters
include Brightness, Contrast, Sharpness, Saturation, Hue, Size, Position, Pixel
number, Pixel phase and Colour Temperature.
To adjust a parameter using the remote control, first press the appropriate command
button then use the
ñ
,
ð
buttons to increase and the
ò
,
ï
buttons to decrease the
value (see System Operation, C—1). If the cursor buttons are not pressed within ten
seconds, the function will be deactivated. If a second function is selected before the
ten seconds have elapsed, the new function will be applied instead.
BÑ13
System Installation
INSTALLATION
LBV00056; Revision A - 23/08/99