Digital Projection LIGHTNING 10sx, User Manual

Page: 145 / 151

If there is no Image
Ensure the input source is sending a signal.
Check the input source is correctly connected, an LED will flash on the input board
at the rear of the projector if you have incorrectly connected the input device. Check
that a signal is being sent (e.g. if it is a video recorder, it is set to play).
Ensure the correct input and channel numbers have been selected.
Check the type of input source and the input number you have connected the device
to, then, select the appropriate settings in the Channel Set-up Function.
Ensure Pic Mute has not been inadvertently selected.
If Pic Mute is ON, press the Pic Mute button on the remote control to toggle it OFF.
Correcting Distorted Images
The image is out of focus.
Activate the On Screen Display then press the LENS button on the remote control
until the Focus dialogue box appears. Next, use the
ñ
and
ò
keys to focus the
image (the
ñ
key will focus closer and the
ò
key will focus further away).
The image does not fit the screen.
Ensure the projector is placed in the correct position, then select the channel with
the required aspect ratio for the image you want to display. The aspect ratio can be
changed using the Modify option in the Channel Set-up function.
The image is stretched horizontally or vertically.
The image is being displayed with the wrong aspect ratio. Before changing the
aspect ratio, ensure you have selected the correct channel for your input device and
the horizontal and vertical sizes are correct.
ii
Appendix
APPENDIX
LBV00056; Revision A - 23/08/99