DIGITAL-LOGIC AG
PCCP5 Manual V2.3
36
4.6.4 BIOS CMOS Setup
If wrong setups are memorized in the CMOS-RAM, the default values will be loaded after resetting the
RTC/CMOS-RAM with the CMOS-RESET jumper. If the battery is down, it is always possible to start the
system with the default values from the BIOS.
The following entries may be made:
Date:
The current Real Date of the RTC
Time:
The current Real Time of the RTC
Drive A or B:
none
= no drive present, FLASHDisk enabled (if device is loaded)
360k
= 5,25" low density drive or FLASHDISK
1,2 MB
= 5,25" high density drive or SRAMDISK
720 K
= 3,5" low density drive
1,44 MB
= 3,5" high density drive (Default for A:)
The A: Drive is the bootable drive.
Display type:
CRT:
for Mono CRT's but no LCD operating possible.
40 x 25:
for Color CGA
or LCD
80 x 25:
for Color CGA
or LCD (Default)
VGA:
for VGA
Harddisk type:
defines which drive is connected
Type = 0 means no drive is present (Default)!
Drive Type 48 and 49 let you define a custom harddisk parameter.
PRESS the AUTODETECT FUNCTION to identify the HD!
WARNING:
On the next Setup pages (switched with PgDn and PgUp) the values for special parameters are modifiable.
Normally the parameters are set correctly by DIGITAL-LOGIC AG. Be very careful in modifying any pa-
rameter since the system could crash. Some parameters are dependent on the CPU type. The cache pa-
rameter is always available, for example. So, if you select too few wait states, the
system will not start
until
you reset the CMOS-RAM using the
RTC-Reset jumper
, but the default values are reloaded. If you are not
familiar with these parameters, do not change anything.
