DIGITAL-LOGIC AG
PCCP5 Manual V2.3
143
state specified in the
Hard Disk Power Down Mode
option (see the previ-
ous selection). The settings are
Disabled
or
1-14 min.
Standby Timeout
(Minutes)
This option specifies the length of a period of system inactivity while in Full
power on state. When this length of time expires, the computer enters
Standby power state. The settings are
Disabled
or
1-14 min
.
Suspend Timeout
(Minutes)
This option specifies the length of a period of system inactivity while in
Standby state. When this length of time expires, the computer enters Sus-
pend power state. The settings are
Disabled
or
1-14 min
.
Slow Clock Ratio
This option specifies the speed at which clock runs in power saving states.
The settings are expressed as a percentage of the standard clock speed.
The settings are
1:1
,
1:2
,
1:4
,
1:8
,
1:16
, 1:32,
1:64
or
1:128
.
IRQ3/4/5/7/9/10/11/12/13/14
Active (at su spend)
When set to
Monitor
, these optins enable event monitoring on the specified
hardware interrupt request line. If set to
Monitor
and the computer is in a
power saving state, AMIBIOS watches for activity on the specified IRQ line.
The computer enters the full on power state if any activity occurs. AMIBIOS
reloads the Strandby and Suspend timeout timers if activity occurs on the
specified IRQ line. No monitoring activity if the option is set to Ingore. The
settings for each of these options are
Monitor
,
Ignore
,
Wakeup
or
Both
.
