Assigning an IP Address
6-2 Configuring the Module in a DIGITAL MultiSwitch 900
Assigning an IP Address
After installing the module in a DIGITAL MultiSwitch 900, connecting the cables, and
assigning an IP address, you need to configure the module. Do this using one of the
following methods:
•
A Telnet session to access the command line interface
•
Through the command line interface, which is accessed through a terminal
connected to the setup port on the MultiSwitch 900
•
Through clearVISN MultiChassis Manager
To perform a Telnet session, you must assign an IP address. To do this, complete the
following steps:
Step
Action
1
Install the module into a slot on the DIGITAL MultiSwitch 900.
2
Redirect the DIGITAL MultiSwitch 900 Chassis Manager setup port to
the VNswitch 900FF slot.
3
Select the IP Configuration option from the menu.
4
Set the in-band IP address.
5
Set the default gateway, if necessary.
6
Return to the
VNswitch 900FF INSTALLATION MENU
and
select
[2] Restart with Current Settings
.
7
Open a Telnet session into the module from the management station for
further configuration. The system displays copyright statements and the
following prompt:
After the system prompt (*) appears, refer to DIGITAL VNswitch 900-
Series Switch Management for further configuration information.
MOS Operator Control
*
