Digital Equipment PRIORIS ZX 6000 MP SERIES, User Manual

Page: 93 / 215

Installing Additional Memory
6-6
Installing SIMMs (MLB)
NOTE:
Prior to installing additional memory in your Prioris
ZX 6000MP Series server, refer to the previous section to
verify the memory configuration you have planned conforms
to all memory configuration guidelines.
To install a SIMM on the MLB, complete the following:
1. Power down your server.
2. Disconnect the ac power, any and all external devices, and monitor
power.
3. Unlock and remove the left side panel.
4. Install a SIMM into a socket at a 45 degree angle away from the
edge connector.
Make sure the notch is oriented as shown (A, Figure 6-3). Rock the
SIMM gently until it completely engages in the bottom of socket.
Tip the SIMM upright until both retaining clips engage (B, C, Figure
6-3).
5. Install the remaining SIMMs (total of 8 SIMMs for Bank 0 on the
MLB).
NOTE:
If you are installing additional SIMMs using memory
modules 1 and 2, refer to the, Installing SIMMs (Memory
Modules) section later in this chapter.