Chapter 6: Local Management: Module Navigation
6-26
DLE49-MA User’s Guide
Trap Destination
(Modifiable)
Indicates the IP address of the workstation to receive trap alarms. Up to
eight different destinations can be defined.
Trap Community Name (Modifiable)
Displays the Community Name included in the trap message sent to the
Network Management Station with the associated IP address.
Enable Traps (Toggle)
Enables transmission of the traps to the network management station with
the associated IP address. This field toggles between YES and NO.
6.7.1
Configuring the Trap Table
To configure the Trap Table, proceed as follows:
1.
Using the arrow keys, highlight the appropriate Trap Destination
field.
2.
Enter the IP Address of the workstation that is to receive traps. IP
address entries must follow the DDN format (xxx.xxx.xxx.xxx).
3.
Press ENTER. If an invalid entry is entered “INVALID IP
ENTERED” is displayed in the Event Message Line.
4.
Using the arrow keys, highlight the Trap Community Name field.
Enter the community name.
5.
Press ENTER.
6.
Using the arrow keys, highlight the Enable Traps field. Press the
SPACE bar to choose either YES (send alarms from the module to the
workstation), or NO (prevent alarms from being sent).
7.
Using the arrow keys, highlight the SAVE command and press
ENTER. The message “SAVED OK” displays on the screen.
The designated workstations now receive traps from the DLE49-MA.
Exiting without saving causes a “NOT SAVED?” message to
appear in the Event Message Field. Edits are lost if they are not
saved before exiting.
