9
DECserver 900GM Installation
Installing the Module (Cont.)
4
Connect the port cables as required.
Connect up to four 68-pin bulk connector cables.
NOTE:
All cables should have been installed, tested, and tagged at
the site before you perform this installation.
a. Insert the bulk connector plug
into the port connector on the
module.
b. Using a flat-blade screwdriver,
tighten the two screws at the
ends of the plug.
NOTE:
To disconnect the bulk cables, use a flat-blade screwdriver to
loosen the two screws at the ends of the plug, then disconnect
the cable.
NOTE:
You must reboot the DECserver 900GM after changing the
bulk cable type on a port from a full modem control cable to a
partial modem control cable or data lead only connector, or
vice versa.
LKG–8761-93I
