8
DECserver 900GM Installation
Installing the Module (Cont.)
2
Seat the module into the DEChub
900 MultiSwitch.
a. Place the module’s mounting
tab into a mounting slot on the
DEChub 900.
b. Pivot the module on the mount-
ing tab and align the connec-
tors.
c. Firmly push the module onto the
backplane connectors until the
release lever clicks.
d. Press down on the release lever
to ensure that it is locked.
3
Verify that the module’s Power
LED and the Module OK LED
light (within approximately 2
minutes).
a. The Power LED lights when
the power is applied, then the
module performs a self-test.
b. After the module completes
the self-test, the Module OK
LED lights and remains lit.
c. The timing depends on the amount of memory installed in the module and the
length of time needed to load the network access software.
NOTE:
Refer to the section titled Problem Solving Using the LEDs if the LEDs do
not operate as described.
Mounting
tab
LKG–8711–93I
Release lever
clicks when
module is
seated.
Hub Manager
status display
LKG–8760-93I