Table 6–3 (Cont.): Software Error Messages
Message
Meaning
Corrective Action
40 LINE ERROR
An error has occurred
in the communication
circuit.
Check the interface parameters (Sec-
tion 4.5.6).
Check the integrity of lines; be sure
cables are properly shielded and that
all ground screws are in place.
41 PRINT CHECK
A misprint has occurred.
Perform the error skip procedure
(Section 6.1).
42 ERROR
There is an expansion
interface error.
Power off the printer and verify that
any memory expansion boards are
correctly installed.
If the problem
continues,
call
Customer
Services
(Chapter 8).
43 ERROR
There is an expansion
interface error.
Power off the printer and verify that
any memory expansion boards are
correctly installed.
If the problem
continues,
call
Customer
Services
(Chapter 8).
FE FONT REMOVAL
A font cartridge has
been removed from
the printer.
Power off the printer and install the
font cartridge before powering the
printer back on.
If you do not want to use the font
cartridge, power off the printer and
wait at least two seconds, then power
it back on.
FF FONT FULL
The font registration
area is full.
Reduce the number of fonts in
memory.
Clear fonts from memory after each
job.
6–6
DEClaser 2200 Printer Operator’s Guide
Summary of Contents for DEClaser 2200
Page 67: ...Figure 2 5 Test Print A MLO 004895 Figure 2 38 36 picas Operating Information 2 39...
Page 71: ...Figure 2 6 Test Print B MLO 004852 Figure 2 39 36 picas Operating Information 2 43...
Page 226: ...Figure C 2 Serial Connections to Modem MLO 004885 Figure C 2 19 picas Specifications C 5...
