24
ReefKeeper Lite User Guide
Programming
Fan
The Fan function is a ReadyFit function. It allows for quick setup of a fan or general cooling
device and requires only a minimal amount of input from the user. If more control is desired, the
Controller function should be used.
This ReadyFit function uses the
iTemp
temp probe that came with your ReefKeeper Lite.
When using the Fan Function, this cannot be changed. For increased function options
please use the Controller Function.
To set up the Fan function
1
From a Module’s Port Menu, select “Function” and press
[Enter]
.
2
Press the
[Up]
or
[Down]
buttons to scroll to “Fan” and press
[Enter]
The “Set Point” prompt will be on the screen with 000.0 and the fi rst digit will be fl ashing.
3
Press the
[Up]
or
[Down]
buttons to set the fi rst digit, press
[Enter]
to set and move to
the next digit. Continue until the value is set.
Example:
Input 085.0 for 85.1°.
4
Once the fi nal digit is set press
[Enter]
to confi rm.
The next prompt is for setting the default state for the output. If the programmed module
can no longer communicate with the head unit, the module will set the output to the state
chosen in the default setting. For example, if a heater is plugged into channel 1 on a PC4
and it can no longer communicate with the head unit, the default state will take aff ect.
5
Press the
[Up]
or
[Down]
buttons to choose between the “On” and “Off ” options.
The screen will change and show “Save”.
6
Press the
[Enter]
button to save.
You can go back from a save by pressing
[Back]
when save is fl ashing.
ReefKeeper Lite User Guide
25
Programming
Chiller
The Chiller function is a ReadyFit function. It allows for quick setup of a chiller or general cooling
device and requires only a minimal amount of input from the user. If more control is desired, the
control function can be used.
This ReadyFit function uses the
iTemp
temp probe that came with your ReefKeeper Lite.
When using the Chiller Function, this cannot be changed. For increased function options
please use the Controller Function.
To set up the Chiller function
1
From a Module’s Port Menu, select “Function” and press
[Enter]
.
2
Press the
[Up]
or
[Down]
buttons to scroll to “Chiller” and press
[Enter]
The “Set Point” prompt will be on the screen with 000.0 and the fi rst digit will be fl ashing.
3
Press the
[Up]
or
[Down]
buttons to set the fi rst digit, press
[Enter]
to set and move to
the next digit. Continue until the value is set.
Example:
Input 079.1 for 79.1°.
4
Once the fi nal digit is set press
[Enter]
to confi rm.
The next prompt is for setting the default state for the output. If the programmed module
can no longer communicate with the head unit, the module will set the output to the state
chosen in the default setting. For example, if a heater is plugged into channel 1 on a PC4
and it can no longer communicate with the head unit, the default state will take aff ect.
5
Press the
[Up]
or
[Down]
buttons to choose between the “On” and “Off ” options.
The screen will change and show “Save”.
6
Press the
[Enter]
button to save.
You can go back from a save by pressing
[Back]
when save is fl ashing.
Summary of Contents for ReefKeeper Lite
Page 30: ......