24
Selecting [OSD] will allow alarms to be triggered, and the letters “AL” ill appear on
the screen of the camera location where the alarm is taking place. A third option,
[OSD+BUZZER] will both display “AL” and emit a buzzer sound in the event of an
alarm.
(ii) CH 1-4:
Set the length of alarm time for each channel between 1~59 seconds.
Additionally, you can select the Alarm Input. The default setting is N/O (Normally Open.
Note:
Some alternative brand PIR motion sensors have a default setting of N.C (normally
closed). In order to activate the alarm on such a PIR motion sensor, change the setting to
N.C
5. MOTION
SET
-
This sub-menu allows you to enable / disable the Pixel-based
Motion Detection function by channel and set its Sensitivity level.
(i) MOTION :
Selecting [OFF] disables the Pixel-based Motion Detection function.
Selecting [OSD] will allow motion to trigger alarms, and the letters “MD” will
appear on the screen of the camera location where the motion is taking place. A
third option, [OSD+BUZZER] will display “MD” and emit a buzzer sound in the
event that motion is detected.
(ii) CHANNEL :
Select which channels will have the Pixel Motion Sensing feature
activated. The Sensitivity level can be set to zero for a channel, which will disable
the Motion Sensing ability for that channel.
(iii) SENSITIVITY :
Select the sensitivity level of the Motion Sensing by channel.
Level 05 is the highest sensitivity, Level 01 is the least sensitive.
Level 00 deactivates Motion Sensing.
(iv) AREA :
Select the area of the screen where the Pixel Motion Sensing feature
will be active. The digits below represent the area on the screen where motion is
detected.
[ 00 ] - Whole screen. [ 01 ] - Top left side of screen.
[ 02 ] - Top right side of screen. [ 03 ] - Bottom left side of screen.
[ 04 ] - Bottom right side of screen. [ 05 ] - Center of the screen
.
6.
SYSTEM SET ( l )
-This sub-menu allows you to configure various preferences
on the system, related to Monitor settings.
(i) KEY BUZZER :
When set to [Y], the system will make a sound when a key is
pressed on the remote control or on the main panel of the monitor.
05
02
03
04
01
00
