Page 57
8
GLIDE COMPASS DISPLAY SCREEN
The are 3 main display screens on the Digifly Leonardo:
- The Thermal Display screen.
- The Glide Compass Display screen.
- The Glide Plotter Display screen.
To switch between these 3 main display screens, press the
key.
The Glide Compass Display screen shows essential vario
information along with a compass, showing Waypoints & Route
information, thermal location, efficiency information, ground or air speed and wind
direction.
For some of these function to be active, Waypoints must have been entered in to the
Digifly Leonardo and a Route acvtivated and a GPS “FIX” achieved.
The Intelliflight function automatically handles the switching between the Glide Compass
Display screen and the Thermal Display screen.
To enable this function, go to (ADVANCED SETUP \ n. 1 IFLY) and set it to “ON”.
The Digifly Leonardo will switch automatically to the Thermal Display screen when the
conditions of a “thermal” are met.
To set the thermal detection parameters, go to (ADVANCED SETUP \ n. 2 THEV) and
(ADVANCED SETUP \ n. 3 THET) to adjust the time over which a change in height is
required for detection of a thermal.
The instrument will then switch back to the Glide Compass Display screen when there is
no lift for more than 10 seconds.
8.1
WAYPOINT MANAGEMENT
When a Route has been activated, from the Glide Compass Display screen you can
select the previous Waypoint by pressing the left arrow key,
(long press).
You can select the next Waypoint by pressing the left arrow key,
(long press).
