29
To program DS2, put each pin in the desired position, according to the table below:
NOTE
-
The grey squares (in bold) in the tables above show the standard
configuration, that is, factory settings.
The detection of user passage is very thorough; these events need to take place, in this
order:
1-
;
Obstruction of first sensor
2-
Obstruction of second sensor (without clearing the first). In this moment, both
sensors must be obstructed
;
3-
;
Clearing first sensor
4-
;
Clearing second sensor
If the events above do not occur in the indicated order, the system may interpret the
alteration as invasion, hitchhiking, or withdrawal and will signal it according to its
interpretation.
Switch
1
2
3
4
5
6
7
8
Final time to close door: 0,50s
ON ON
Final time to close door: 1,25s
OFF ON
Final time to close door: 2,00s
ON OFF
Final time to close door: SMART SPEED*
OFF OFF
Enables credit accumulation
ON
Disables credit accumulation
OFF
Speed of door movement: LOW
ON
Speed of door movement: HIGH
OFF
Enables Safety Mode (does not close door with sensors blocked)
ON
Disables Safe Mode (closes the doors even with sensors blocked)
OFF
Retention time of card in the box for reading: 1s
ON
Retention time of card in the box for reading: 2s
OFF
Confirming passage by disk emulation
ON
Confirming passage by pulse
OFF
dTower operational mode
ON
CLIP operational mode
OFF
DIP SWITCH DS2
Tower
Summary of Contents for dTower
Page 1: ...1 11 Produ t Manual c Tower...
Page 2: ...2...
Page 46: ...46 Notes Tower...
Page 47: ...47 Tower...
