19
6.4.1.2
Pictogram
NPN transistors (maximum 500 mA) activate pictogram's output. In the moment of
activation, the GND is sent through the corresponding output.
6.4.2 Configuration of control board - Switch Ds1
The switch (or dipswitch) DS1 allows programming the following actions:
-passage direction
-Maximum time for passage
-NO inputs (relay or pushbutton contact normally open and without input voltage),
enabling passage in face of these signals; or NC inputs (relay or pushbutton contact
usually closed and with input voltage), enabling passage in the absence of these
signals.
-enabling of a signal for a sound alarm if the access control remains at mid passage
for more than 2 seconds.
To program DS1, put each pin in the desired position, according to the table below:
clip
12 11 10 9 8 7 6 5 4 3 2 1
12 11 10 9 8 7 6 5 4 3 2 1
BOX SENSOR
ELECTROMAGNETS
TURNSTILE SENSORS
DIGICON CONTROL BOARD
INPUTS CN8
OUTPUT
Cn9
GND
+ 24V / 12V
OUTPUT
NPN 500mA
OUTPUT
NPN 500mA
OUTPUT
NPN 500mA
PT
VM
VD
AZ
LR
PT
VM
VD
AZ
LR
RED
RED
/
/
GREEN
GREEN
XXXXXX
Number of board’s
version
