10
5.2 Floor drilling and column fixation
Before installing
, check:
CATRAX Clip
1
. The place chosen for the installation.
2
. If there is a power source or electric socket nearby (ducts for connection).
3
. If the place chosen is adequate for the installation of the access controller
(indoors).
4
CATRAX
. If there will be enough space (minimum 5 cm) between the rear of the
Clip
column and the wall. This space is important in order to provide access to the
upper panel and plug's locks for the cables passage.
5
CATRAX Clip
. If there will be enough space for the arms after
is assembled.
6
. If the floor is in conditions to receive anchor bolts (minimum of 4 cm of FCK15
M.P.A. concrete or equivalent).
ATENTION:
To see details on the dimensions of
, see item 8
CATRAX Clip
(technical characteristics).
To fixate the column to the floor, observe the following steps and the indicated
images:
1
. drill the floor with 3/8” drills (then use a 12mm or the ½” drill). Make four external
holes, according to the measures indicated in the image below:
2
. Clean the holes, removing any debris from drilling.
3
. Place the external part of the bolts in the holes. Leave about 25mm of the bolt out
of the hole.
4
. Position the column and fasten it to the floor with the four screws that accompany
the bolts. Use a flex-head socket wrench with ¾'' or an articulated socket wrench.
TIP:
We recommend the bolts by the brand Tecnart, model AF38110,
3/8x4''.
clip
12,5 (4x)
210
(8,267")
170
(6,692")
78
(3,070")
36
(1,417")
Saída de cabos
92,5
(3,641")
32
(1,259")
20
(0,787")
Furação
de fixação
51
(2,007")
79,5
(3,129")
160
(6,299")
