Get started with Digi ConnectPort X Family products
Install the SIM card
Digi ConnectPort X Family
24
Equipment
Description
Wire whip antenna
Install the SIM card
You must install a SIM card if you want to use a cellular connection. There are two SIM card slots on
the circuit board. The primary slot is the slot closest to the lid, and the secondary slot is the slot
farthest from the lid.
Note
If your device does not use a SIM card, you can skip this step.
There are two SIM card slots on the circuit board. If you are only using one SIM, insert it into the
primary SIM slot, which is the slot closer to the top of the product.
1.
.
2. Insert the SIM card(s). If you are only using one SIM card, insert it into the primary SIM slot.
a. Insert the primary SIM card in the primary SIM slot, which is the slot closest to the
lid. You must insert the chamfered edge of the SIM card first with the contacts face
down. When properly inserted, the SIM card clicks into place.
b. Insert the secondary SIM card in the secondary SIM slot, which is the slot furthest
from the lid. You must insert the chamfered edge of the SIM card first with the
contacts face up. When properly inserted, the SIM card clicks into place.
3.
. If you are going on to
, you can leave the lid open.
Note
If you do close the device, Digi recommends that you use 2.5 inches per pound of torque
when tightening the screws. You should tighten the screws in a criss-cross pattern to ensure
that the cover is not bent or skewed during this process.
Attach the Ethernet cable
You can attach an Ethernet cable to the device so that you configure your device using the local web
user interface. The Ethernet cable is attached inside the device.
Note
You can also route an Ethernet cable outside the device enclosure. See
.
