The counter at the top left corner
displays the memory left for
further races. Further races can
be recorded by pressing A and B
buttons as above.
** Since 5 memories are used for
memorizing the date and number
of the race, the memory left will
be 1993 as shown below.
Press D to recall data stored. The
display which we call the
RACE
RECORD
is as shown in Fig. 8.
The display shows the date in
which the race was recorded and
MCH-001(
MSP
for
SPEED
mode)
stands for the first race recorded
in
LAP/SPLIT
mode at that date.
** Pressing B button when the
stopwatch is displaying the
RACE RECORDS
will show the
next
RACE RECORD
(if there is)
and the
LAP TIMES
in this
RACE RECORD
can be recalled
by pressing D.
** Pressing and hold A button when
the stopwatch is displaying the
RACE RECORDS
will clear the
memories in that race record (
when the contents in this race
record are cleared the display will
show
CLEARED
and sounds a
long beep, if A is released before
ED
appears the memories will not
be cleared ) and continuously
holding A button after this will
clear the memories of all races
(display will show
ALL
CLEARED
and display will return
to as shown in Fig. 2. Memories
are available for storage when
they are cleared.
Press D again to recall the 1st
LAP
data, as shown in Fig.9.
Press D to recall the 2nd
LAP
data, as shown in Fig.10.
Press D again shows the stopped
time, as shown in Fig.11.
Press D again to show the average
LAP
time, as shown in Fig.12.
Press D again to show the Best
LAP
time, as shown in Fig.13.
** The
AVERAGE
calculation and
BEST
record do not take into account
the last section of time before
STOP
. Therefore, in order for the
stopwatch to keep track of the
average and best records of all
Laps, always use the B button
until the end of the race.
Pressing D again will go to the
next race records or return to the
1st race
records (if there is no further
race).
In the
CHRONO MODE
before
the start of a race, such as in
Fig.7, push and hold B for 2
seconds will go to the
SPEED
SET
mode as is shown in Fig.14.
The first digit in the lowest row is
flashing to indicate setting of the
thousandth digit of distance.
Push A to set and B to select the
next digits. The highest setting
for distance is 9999.999.
After the digits are set press B
again to set the
TIME
unit with
the
top
left
corner
HR
flashing. Use A to set to
HR
(for
/hour),
MIN
(for
/minute) or
SEC
(for/second).
When the distance and time unit
are set, press C button to return
to the
SPEED MODE
(Fig. 15).
(Pushing C button anytime during
the setting will return to the
SPEE
D
mode
).
Fig. 14
Fig. 15
Press A to start, the display is as
shown in Fig.16.
Press B to get the 1st
LAP
time
at the top row and the speed at
the middle row, as shown in
Fig.17.
If for example the
distance is set to 200 meters and
time unit set is in seconds, the
speed calculated from a
LAP
time
of 17.09 seconds is 11.70 m/sec.
Using the B button the
LAP
times
and their corresponding speeds
can be
displayed.
Recall
operations in the
SPEED
mode
are the same as that in the
LAP/SPLIT
mode.**
BASE 3
STROKE/FREQ
-- if the distance
Fig. 8
Fig. 7
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 16
