USE CONVENTIONAL dry-SpLICE WATErprOOF
CONNECTOrS.
Leave some slack on each side of the
wires so that repairs, if needed, can be carried out easily
(see d)
.
NOTE:
Subsequent 710 Models (only) will have the
solenoids hard wired into the controller eliminating
the need for waterproof connectors.
7. Mount the controller – see section 4 on page 4 for wall
or valve mounting (
see E, G, h
).
8. After installation is complete, turn on the water supply
and pressurize the mainline. the valves will open
momentarily and then shut off. test each valve in
manual operation by moving the manual handle from
left to right to open and right to left to close. Do this to
make sure that the valve is operating correctly (
see F
).
9. Program the controller
(see section 8 on page 11).
6
warning: FaiLUrE TO USE
waTErprOOF cOnnEcTOrS
wiLL vOid ManUFacTUrEr’S
warranTy
D
G
F
H
Sensor
E
