Diesse VES-MATIC EASY, Service Manual, Page: 13 / 76

Service Manual
[13/76] 7 Rev.1.1 of 15/04/2017
2.3. EQUIPMENT / INSTRUMENTATION REQUIRED
-
Multimetre - Mod.Fluke 8010A or equivalent.
-
Set of screwdrivers.
-
Set socket-head spanners.
- 5.5mm Plug socket spanner.
- 10 Cuvettes containing 2ml Latex [*]
-
10 Cuvettes containing 3ml Latex [*]
[*: Diesse Code 10406: 1 cuvette with 2ml Latex + 1 cuvette with 3ml Latex]
2.4. DISASSEMBLY AND REASSEMBLY PROCEDURES
Disassembly procedure
a) Follow the instructions in paragraph 2.2 points a) and b).
b) Remove the lower lid code 10602170 (Pos.007-Tab.300033800), lift up the printing head (see
point 3.2) and remove the paper from the printer.
c) Use a screwdriver to unscrew the 4 screws M3x12 (Pos.203-Tab.30003800) anchoring the front
panel code 30208601 (Pos.002-Tab.30003800) to the rear panel code 30208611 (pos.001-
Tab.30003800).
d) Ease out the upper lid (Pos.006-Tab.30003800) anchored to the side panels by the springs on
the moulds.
d) Disconnet the wiring attached to the Ves-Matic Easy Connection Board (Pos.101-Tab.30003800)
in order to access the electrical and mechanical parts of the instrument.
Reassembly procedure
Follow the steps of the disassembly procedure in reverse.
Make sure to prevent the wires from becoming entangled in the mechanical parts during
this phase.
Pay attention when screwing the 4 screws M3x12 (Pos.203-Tab.30003800) to re-attach
the front panel code 30208601 (Pos.002-Tab.30003800) to the Rear Panel code 30208611
(pos.001-Tab.30003800):
do not screw too much to avoid plastic’s covers
deformations .