V3.01.51
6
2) RECEIVER: Installing the Receiver (WR420/425)
a) Slide toggle switch to the ON position (this will allow Receiver to use
battery backup power if AC power is lost)
b) LED will flash blue/red/green for 2 seconds
c) Plug in AC adapter to Receiver and a local outlet.
d) Connect USB cable to available USB port on PC and to Receiver
e) Open WiZARD2.4 software via desktop shortcut
f) Enter Login ID:
admin
(WiZARD2.4 SECURE only)
g) Enter Password:
Dickson
(WiZARD2.4 SECURE only)
h) Click OK (WiZARD2.4 SECURE only)
i) Status Screen will open.
j) Lower left corner in WiZARD2.4 software
will read “Receiver Update
Mode”
k)
“Receiver ID Entry” window will pop up.
l) Enter any ID you wish
(4 digits only (0-9 and A-F)
i)
“0000” and “FFFF” are not valid ID’s
ii)
NOTE:
Each device (Logger/Repeater/Receiver) must have a unique
ID
m) Click OK
n)
Lower left corner of window will read “re-starting”, then “connected”,
followe
d by “retrying polling command”, then “connected” again. This may
take a couple minutes depending on the PC.
o) The Receiver is now connected.
p) If a polling failure command appears, check to make sure you are using
XP with Service Pack 3. Older XP versions can cause the USB to fail.
q)
NOTES:
i) The Receiver will always require power directly from the AC adapter.
ii) Batteries for backup are recommended to prevent the system from
locking up if there is a sudden loss of power or brownout.
If you purchased a Signal Sensor WS400, follow the steps below if not skip
this section.
3) SIGNAL SENSOR (WS400):
a) Once the Receiver has been installed, go to each designated Logger and
Repeater location, with the Signal Sensor, to determine if the Receiver
signal strength will be strong enough to reach that location. (See Signal
Sensor Operating Instructions below.)
b) The display will indicate if the Receiver can be found and how strong the
signal is.
IMPORTANT:
When adding USB devices many PC’s will prompt you to
reboot the PC once the device is added. Respond NO to this message.
Do
not reboot the PC unless WiZARD2.4 Software has been closed first.
