Dickey-John DjASM II, Operator'S Manual

Page: 18 / 28

OPERATOR’S MANUAL
Dj ASM II Air Seeder Monitor
11001-1311-200501
SYSTEM OPERATION / 15
Figure 18
Example of All Rows Failure
DIMMING
A dimming feature is included for low light planting conditions. After the
sensor detection has been completed and only during non-alarm
conditions, the dim switch can be toggled into the up position to dim the
indicators. Each dim step will cause the alarm to chirp. Once the lowest dim
level has been reached, the alarm will sound for 2 seconds. After 2
seconds, or if the switch is released and toggled up again, the indicators will
brighten. Once the highest brightness level has been reached, the alarm
will sound for 2 seconds.
LIFT SWITCH
The lift switch input will keep the ALL ROWS FAILURE from occurring.
When the Lift Switch input is grounded, it is considered active (inhibits ALL
ROWS FAILURE). When active, the Module Display will output an “L” and
will no longer scan through the modules. The alarm will chirp.
Figure 19
Active Lift Switch
HOPPER LEVEL LOW
Hoppers can be monitored with the Dj ASM II console in the event a 15 row
Hopper Module is connected to the system. If a hopper is low, the sensor
will ground the signal line and an “H” will appear on the display, indicating a
hopper is empty. The LED number indicates which module the hopper level
sensor is connected. In the following example, the hopper sensor on
Module 4 is indicating a low hopper.
Chirp
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Chirp
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16