Dickey-John DjASM II, Operator'S Manual

Page: 10 / 28

OPERATOR’S MANUAL
Dj ASM II Air Seeder Monitor
11001-1311-200501
SYSTEM CONFIGURATION / 7
SYSTEM CONFIGURATION
SPLIT ROW ENABLE
This feature will set the Dj ASM II to monitor only odd or even numbered
rows.
To configure the Dj ASM II to monitor only even numbered rows, hold the +/
- switch to “+” and turn the power switch ON. The letter “E” as well as the
even row indicators will be displayed. Release the +/- switch immediately.
Figure 7
Even Row Enable
NOTE: Turning the power switch ON
with the +/- switch in the center
position configures the system
to monitor all rows.
To configure the Dj ASM II to monitor only odd numbered rows, hold the +/-
switch to “-” and turn the power switch ON. The letter “O” will be displayed
as well as the odd row indicators. Release the +/- switch immediately.
Figure 8
Odd Row Enable
MINIMUM SEEDING RATE
The Minimum Seeding Rate feature allows for setting a minimum number of
seeds per second that will cause a seed row to fail and alarm to sound. The
factory default minimum seeding rate is 2 seeds per second.
To set the minimum seeding rate, perform the following:
1. Power up the console and wait until the start up test of modules, seed
sensors, and hopper level sensors is complete.
2. Momentarily hold the +/- switch in either the “+” or “-” position to
change the threshold adjustment setting.
3. Refer to Figure 9 and enter the desired threshold.
4. Holding the +/- switch to the “+” position will increase the LED’s.
Holding the +/- switch to the “-” position will decrease the LED’s.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16