11
3 0 0 S E R I E S O W N E R’ S M A N U A L
300EL Assembly Instructions
Frame Assembly
1.
Place the unit and all accompanying parts in a
clean, flat and open space.
2.
Attach the Stabilizer Bar to the Frame using two
M10 bolts with two M10 nuts. Tighten these bolts
firmly using an Allen wrench on the bolt and a box
wrench on the nut.
Console Mast Assembly
1.
Hold the Console Mast up above the post on the
front of the frame, with the Tension Adjuster facing
toward the rear.
2.
Slide the Console Mast onto the post. Note: Be
careful not to pinch the wire or tension cable
while doing this, doing so could cause the unit
to operate incorrectly.
3.
Slide the Console Mast Cover up the Console
Mast to allow access to the boltholes at the bot-
tom of the Console Mast. Attach the Console Mast
to the Frame using three M8 bolts.
Console Assembly
1.
Hold the Console up to the top of the Console
Mast and attach the three wires from the Mast to
the back of the Console. Raise the Console to the
front of the Mast and slide the slot in the back of
the Console onto the top of the Mast. While slid-
ing the Console on, feed the slack in the wires
into the Mast.
Note: Be careful not to pinch the wires while
doing this, doing so could cause the unit to
operate incorrectly.
2.
Once the Console is in place on the Mast, attach
it in place using four M5 x 15mm bolts.
Handlebar Assembly
1.
Slide one Handlebar onto its post on the top of
the Frame. If the Handlebar is on the correct side,
the bolt holes at the bottom of the bar will line up
with those on the post and the Handlebar will arc
forward from the frame.
2.
Slide the second Handlebar onto the other post.
Check both handlebars to make sure they are on
the correct sides.
3.
Attach both Handlebars on the posts using three
M8 bolts on each.
