6
Installation and Operation
SAW STAND SETUP
1. Remove the folding stand from its box.
2. Remove the two lock pins inserted through the sides of
the stand. While holding the stand upright, spread both
sets of legs apart and swing the workbench over and on
top of the legs.
3. Insert lock pins through the legs and into the workbench.
Seat the saw onto the stand. Secure the saw to the
stand using the two provided wing bolts.
(see fi gure 2)
BLADE INSTALLATION
1. Loosen blade guard adjustment knob located at the rear
of the blade guard. Raise the blade guard to the highest
position and retighten the knob.
2. Remove the blade shaft nut and outer fl ange.
(see fi g-
ure 3)
If a blade has been mounted, hold the blade with
one hand and use the other hand to loosen the nut with
the universal wrench. Remove existing blade.
3. Mount new blade, but make certain the arrow on the
blade coincides with the rotation direction of the shaft.
4. Attach outer fl ange and blade shaft nut. Hold the blade
with one hand and use the other hand to tighten the nut
with the universal wrench. Make certain the fl anges are
pressed fl ush against the blade and that the nut is fi rmly
tightened, but do not over tighten.
5. Loosen blade guard adjustment knob, lower the blade
guard and retighten the knob.
WATER PUMP INSTALLATION
1. Remove the water pump from the box and check that it
is not damaged.
2. Place the pump onto the recessed area of the water
tray. The pump should be oriented such that the water
outlet is horizontal.
(see fi gure 4)
3. Connect water hose from the bearing housing located
on the underside of the cutting head to the water pump.
Plug the pump’s power cord into the receptacle on the
switch box located above the cutting head.
4. Fill the water tray so that the water intake is fully im-
mersed. Proper water level must be maintained at all
times during saw operation.
Disconnect the pump before attempting to handle the
pump.
Never
operate pump without water in the tray.
Never
Never
WARNING:
fi gure 3
fi gure 2
fi gure 4
