CC1000T • Owner’s Manual
13
3. If the table shifts to the right as it travels away from the
user, a shim needs to be added to the guide roller fur-
thest from the ruler guide. On the other hand, if the
table shifts to the left, a shim needs to be added to the
guide roller closest to the ruler guide. Remove the ap-
propriate guide roller to insert a shim between the roller
and table, then reattach.
(see fi gure 15)
Depending
on the severity of the shift, more than one shim may be
required.
4. After adding shim(s), mount the table onto the guide rails
by reversing the instructions in step 2. Move the rails to-
ward each other to engage the horizontal rollers to the
right guide rail as shown in
fi gure 11
. Realign the table
to the blade using method 1. Check to see if any shifting
persists. A shift tolerance of 0.2mm is allowed. A shift
in excess of that will require further adjustment—repeat
step 3.
Horizontal
Roller
Flat Roller
fi gure 15
Shim
Guide Roller
Method 2:
This procedure corrects another source of misalignment
that occurs when the table’s orientation is not parallel with
the guide rails.
1. Use the universal wrench to loosen (but not remove) the
fasteners from either end of both guide rails. Move each
rail away from the other, so that the horizontal rollers are
clear of the right guide rail.
(see fi gure 12)
2. Remove rubber cap A on the left side of the table. Loos-
en the exposed lock nut using a 13mm socket wrench.
Use a fl at screwdriver to turn the shaft of the roller clock-
wise to lower it by approximately 3/8”.
(see fi gure 13)
Evenly lift up the table to disengage the guide rollers
from the left guide rail. Once the guide rollers are clear,
shift the table to the right to clear the left horizontal roller
of the rail. Remove the table from the guide rails.
(see
fi gure 14)
Rubber Cap B
fi gure 13
Flat Screw Driver
Size 13mm
Socket
Wrench
Rubber Cap A
Rubber Cap C
fi gure 12
Horizontal Roller
Clearance
Right Guide Rail
Loosen Fasteners
Guide Roller
Horizontal Roller
fi gure 14
1
2
Left Guide Rail
