D i a l o g i c P C I L i n e c a r d s
1 9
1081-50821-00 Rev 01
October 2011
Configuring the Default Line State (D/41 and D/120 only)
D/41JCT-LS and D/120JCT-LS linecards have a switch to configure the initial hook state. This
switch determines how the linecards responds to incoming telephone calls when the Call Server
platform power is on, but either OneBox or the Dialogic system software is not running.
If the switch is in the OFF position, the default line state is onhook; callers get a ring-no-
answer (RNA) response. (This is the factory default setting)
If the switch is in the ON position, the default line state is offhook; callers get a busy
signal.
NOTE
If the computer platform is powered off, callers get an RNA response.
Aastra recommends that you set the default line state to
offhook
. To change the default hook-
switch line state of the linecard to
offhook
, flip the line state switch (SW4 on the D/41JCT-LS or
SW1 on the D/120JCT-LS) to the ON position as shown in Figure 15.
Figure 15: SW1 or SW4 Line State Switch
Removing the Slot Retainer Bracket
In certain platforms it may be necessary to remove the slot retainer bracket from the inside edge
of the linecard.
To remove the slot retainer bracket
…
1. Refer to the specific linecard figure for the location of the slot retainer bracket.
2. Remove the slot retainer bracket by removing the two retaining screws.
