Dialogic
®
DSI SS7G41 Signaling Server – SIU Mode Release Notes
Release 1.2.10
37
3.13
Message Router – Concerned Entity (IPY00102349)
This release corrects an issue encountered at startup when using Message
Router Functionality in conjunction with a local User Part (e.g. SCCP) as a
Concerned Entity whereby initial availability of the destination is not notified
to the User Part.
3.14
Maintenance Logs
Additional events generated from MTP3, TCAP, M2PA and SCTP are now
logged and or decoded in the maintenance log and sent to the management
host. These messages include the following: MTP_MSG_LINK_CONG,
TCPEV_DLG_TIM_TIMEOUT, TCPEV_EXCESSIVE_DLG_ABORTS,
M2P_MSG_EVENT_IND and SCTP_MSG_EVENT_IND.
3.15
Timestamps following restart
This release ensures that when using Network Time Protocol (NTP) the
timestamp maintained by the built-in hardware clock is updated to the NTP
time. This ensures that any timestamps in the diagnostic ‘messages’ file
generated immediately following a restart (which would be derived from the
hardware clock) are correct.
3.16
NTP Operation (IPY00102543)
The release corrects an issue which resulted in a spontaneous unit restart
when NTP was active but had failed to achieve NTP synchronization as a
result of the time difference between the two servers exceeding a set
threshold (1000 seconds). The restart would occur after approximately 9
hours of operation.
Now if unable to obtain synchronization, the unit will show the NTP status as
inactive and will stop attempting to synchronize. To recover from this
condition the user should manually reactivate NTP.
Dialogic
31-May-13
