Dialogic
®
DSI SS7G41 Signaling Server – SIU Mode Release Notes
Release 2.3.2
11
Operation of the SS7LD board is that when set to recover clocks it will always
use the lowest numbered interface that contains a suitable signal. When
using drop and insert to pass bearer circuits to a media processor, the user
should take care to use the lowest number interfaces for network facing
connections and the highest numbered interfaces for local (media)
connections.
3.2
IP Logging
This release corrects operation of the IPLGI command by ensuring that the
command is only accepted if the IPADDR parameter is set to an actual IP
address value. Previously IP logging could be inadvertently disabled.
3.3
Alarms - Severity
The setting of the ‘Alarm Severity’ field in the alarm log has been corrected
so that the original severity is retained even when the alarm has cleared. The
‘Alarm State’ should be used to determine which alarms are currently active.
3.4
Alarms – SCTP Path Failure
This release corrects an issue with the SCTP Path Failure alarm which
sometimes prevented the alarm clearing when the path recovered.
3.5
MSSLP Command – Peak Utilization Monitor
The per link Peak Utilization Monitor on page 3 of the MSSLP command now
reports Peak Rate to one decimal place and Peak Load to two decimal places
in Erlangs for MTP2 links and Link Equivalents for M2PA links.
3.6
M2PA – Timer T2
This release corrects an issue which, in some cases, resulted in failure to start
M2PA timer T2. This ensures that if the peer is not responding the link will
periodically drop back to Out of Service and then reattempt alignment.
Dialogic
28-Nov-14
