Dialogic
®
DSI SS7G41 Signaling Server – SIU Mode Release Notes
Release 1.2.10
36
3.4
STSTP Command - SIGTRAN Status
This release improves operation of the STSTP when PAGE=2 to ensure
appropriate reporting of path status for associations that are not in the active
state.
3.5
SS7MD – Increased buffer allocation
This release increases internal buffer resources for the SS7MD board to
prevent failure of SS7 links when operating with high throughput applications
with high numbers of SS7 links.
3.6
ISUP - OPC Validation
The release removes the ISUP Circuit Group configuration requirement that
the OPC must have already been used as a local point code for an SS7 link
set or SIGTRAN Local Application Server.
3.7
TCAP – Dialog Idle Timer
This release corrects a fault with the TCAP Dialogue Idle Timeout which
previously resulted in timeouts greater than 6,553 seconds expiring early.
3.8
M3UA – Route availability (IPY00102249)
This release corrects a problem (introduced in Release 1.2.0) that results in
M3UA sometimes failing to detect remote point code availability when a route
becomes available. The fault occurs when a DAVA from the network is
preceded by a SCON message indicating a congestion status of zero. As a
result SCCP and Message Router deployments might have failed to detect
point code recovery.
3.9
config.txt - STN_LINK Local IP Address
The release adds a validation check for the STN_LINK command to prevent
attempts to configure a local IP address which has not previously been
configured as a system IP address.
3.10
config.txt - MRCEI Command
This release improved the error reporting in the event that the configured
ALIAS already exists. The error code ‘already used’ will be displayed.
3.11
config.txt - STN_ROUTE for Message Router
This release provides a correction to Message Router Functionality in cases
where the NETWORK domain contains destinations that are accessible via
routes define using the STN_ROUTE command. This ensures that messages
from the AS domain can correctly be routed to the NETWORK domain.
3.12
Message Router - Tracing
This release adds support for tracing messages received from an Application
Server and for messages sent from the Message Router to a User Part.
Previously tracing of these events was either not supported or not supported
in PCAP format.
