Dialogic
®
DSI SS7G41 Signaling Server – SIU Mode Release Notes
Release 2.3.9
7
3.14
SCCP – GTT using Translation Type 2
This release corrects operation when configuring SCCP Global Title Translation
rules which use GT Translation Type 2. In previous releases, using an odd
number of GTAI digits in the pattern or address (including any separators)
would cause the Signaling Server to incorrectly pad the GTAI digits with an
additional zero. This has been corrected.
3.15
SIGTRAN Route - Congestion Level
When viewing the status of a SIGTRAN route (using the browser interface or
the STSRP command) the current congestion level is now displayed using the
CONG_LEVEL parameter.
3.16
SIGTRAN Link Port Validation (IPY00117305)
This release provides enhanced checking of SIGTRAN link configuration
parameters to prevent invalid configurations being accepted but subsequently
failing to operate. Specifically all associations using the same local port value
must use the same set of Local IP addresses.
3.17
SIGTRAN Link Measurements
This release corrects reporting of the ‘Out of Service Duration’ for M2PA links
and allows SIGTRAN Link measurements on page 1 (SCTP) and page 2
(M3UA) to be individually reset on a per-page basis.
3.18
DTS Routing (IPY00117001)
This release corrects the operation on the ‘Route on Billing ID’ when using
DTS in conjunction with host-based IS41.
3.19
ACPOS Command - Account Control Policy
This release corrects operation of the Account Control Policy Configuration
command, ACPOS when the WMSER parameter is set to HTTPS.
3.20
License Commands
The licensing configuration and status commands have been improved. The
CNLCP command now reports the actual licenses present on the system and
their throughput, where applicable, in link equivalents. The STLCP command
reports the actual capacity, in link equivalents, of the licensed transport layer
capabilities.
3.21
Log files
Following a restart, logging to the mmi, maintenance, stats and alarms log
files now appends to the existing file rather than starting a new file. This
ensures better utilization of the available disk capacity.
3.22
IP Logging
This release corrects an issue that previously could result in PCAP logging to
the syslog/iplog file stopping spontaneously.
Operation of IP has been enhanced so that it continues to operate during
periods of system overload. Previously logging was disabled during periods of
overload.
