S Series Shelter
Operation & Maintenance
95310-02
2-12
DHS Systems, LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may
be reproduced for release to a third party without written consent from DHS Systems LLC
.
016.01 Pre 2003 S Shelter-to-Shelter Connector Set (Prior to 01 JAN 2003)
The Shelter-to-Shelter Connector Set provides a weather and light tight connection between any two Shelters. The
Connector Set will attach to any doorway on any Shelter unit. The connector set consists of an interior connector and an
exterior connector. To connect multiple Shelters together:
1.
Remove the Connector Set from bag.
2.
Starting with the exterior connector, locate the peak. The peak of the connector has a grommet and cord. Match the
peak of the connector with the peak of the doorway (the peak is the top grommet on the Velcro connector strip).
Using the cord, tie the exterior connector to the Shelter. Repeat the process for opposite side of the connector.
3.
Once the peaks are attached, position one person outside
the Shelters. Starting with the underside, secure the
Velcro connector strip to the doorway working from the
top to the bottom about 1.5 feet at a time. Complete the
connection by securing the topside of the Connector
Strip.
4.
From inside the Shelter, locate the Velcro strip on the
underside of exterior connector floor. Attach this to the
Velcro strip on the base of the connector wall.
Figure 2-16 - S Shelter Exterior Door
5.
To attach the interior connector, locate the peak. This
peak has red tabs.
6.
Align the red tab with the red tab found on the interior connector strip and secure.
7.
Repeat process for other side of the connector. Once both peaks are attached, work your way down 1.5 feet at a time
until the strips are fully connected.
8.
At the connecting doorways of both
Shelters, detach the Floor from the
Ground Cover, exposing the Velcro.
9.
Attach Velcro strips from the interior
connector Floor to the Velcro found on
the Ground Cover.
10.
Replace the floor
NOTE
IF THE CONNECTOR SAGS, IT MAY BE NECESSARY TO
MOVE ONE OF THE SHELTERS AWAY FROM THE OTHER. IT
IS EASIER TO MOVE THE SMALLER SHELTER. IT IS
ADVISABLE TO INSTALL THE FLOOR OF A SMALLER
SHELTER AFTER THE INSTALLATION OF THE CONNECTOR
SET
BROWN TAB
