24
DHOLLANDIA
NOTICE
CAUTION
•
If you intend to weld, ALWAYS follow the NOTICE and CAUTION with regards to welding in section 4 on page 6.
•
Make min. 6 pcs.
3
8
” (10
mm) welds, min. 4” (10
0 mm) long,
evenly spread around the periphery of the mount plates (per
plate).
•
When there is an overlap between the mount plates and the
long sills, make min. 2 pcs.
3
8
” (10mm) weld
s
, min. 4” (10
0
mm) long, at the top of the mount plates (per plate).
•
If there is no overlap, add a connection plate to extend the
height of the mount plate, overlap the long sills, and make
min. 2 pcs.
3
8
” (10
mm) welds
, min. 4” (10
0 mm) long, at the
top of the mount plates (per plate).
•
Apply welds at the top of this connection plate to join the plate
to either the long sill or the vehicle cross members.
NOTICE
•
It is essential that bolts and nuts used to mount the lift frame to the chassis, are fastened with the required torque (see values for
“shear”).
•
If you use mounting bolts not supplied by DHOLLANDIA, obtain confirmation of the required torque from your supplier and make
sure they guarantee at least an equivalent strength.
•
Check and retighten the bolts after the static and dynamic weight test performed during the PDI test
WARNING
•
During installation, the bolts and nuts should be fastened to the proper torque, shown in these installation instructions.
•
If you use mounting bolts not supplied by DHOLLANDIA, make sure the total strength is at least equivalent as per this manual.
•
Check and retighten the bolts after static and dynamic load tests performed at the end of the installation process.
