25
1. Plug the probe into the front panel, turn on the unit, and wait until the unit is
ready to take a measurement.
2. Press
the
CONFIG
key and the display will briefly indicate:
and then the first configurable parameter will be displayed.
3. Press
the
ENTER
key repetitively until the display indicates:
4. Use
the
↑
or
↓
keys to select “Xfer Enabled” on the bottom line of the display.
5. Press
the
ENTER
key to enable the data transfer interface. The display will now
indicate:
PACHETTE 2
CONFIG
EXT. INTERFACE
Disabled
BAUD RATE
9600 bps
Note:
To disable the data transfer interface, follow steps 1 thru 3 above, select
“Disabled” in step 4, and then press
ENTER
.
6. Use
the
↑
or
↓
keys, if necessary, to select a baud rate for the
Pachette 2
(9600 is
the default setting) that matches the baud rate of the computer interface.
7. Press
the
CLEAR
key to save and exit the configuration menu.
Connecting The Pachette 2 To A Personal Computer
1. Turn off the power switch on the
Pachette 2
and on the computer.
2. Plug
the
Pachette 2
AC power cord into the back panel of the
Pachette 2
and into
a three-prong AC outlet.
3. Connect the computer AC power cord into a three-prong AC outlet.
4. Connect the RS232C data cable between the
Pachette 2
and the computer. A 25-
PIN, “D-Type” connector mates to the rear of the
Pachette 2
, and either a 9-pin
or 25-pin “D-Type” connector mates to the computer RS232C interface (also