3
Award BIOS Setup Utility
41
Resume On LAN
The Wake-On-LAN function allows the network to remotely wake up
a Soft Power Down (Soft-Off) PC. However, if your system is in the
Suspend mode, you can wake-up the system only through an IRQ or
DMA interrupt. Make sure your LAN card supports the remote
wakeup function.
To use the Wake-On-LAN function, set this field to Enabled. Refer to
the Wake-On-LAN Connector section in Chapter 2 for more
information.
Resume On Alarm
Enabled
When Enabled, you can set the date and time you would
like the Soft Power Down (Soft-Off) PC to wake up.
However, if the system is being accessed by incoming calls
or the network (Resume On Ring / Resume On LAN)
prior to the date and time set in this field, the system will
give priority to the incoming calls or network. Date (of
Month) and Timer (hh:mm:ss) will appear right below
this field.
Disabled
Disables the automatic wake up function. (default)
Date (of Month)
0
The system will power-on everyday according to the time
set in the Timer (hh:mm:ss) field.
1-31
Select a date you would like the system to power-on. The
system will power-on on the set date, and time set in the
Timer (hh:mm:ss) field.
Timer (hh:mm:ss)
This is used to set the time you would like the system to power-on.
If you want the system to power-on everyday as set in the Date (of
Month) field, the time set in this field must be later than the time of
the RTC in the Standard CMOS Setup.
