3
Award BIOS Setup Utility
75
MACPME Power Up Control
This field is used to enable the Wake-On-LAN function of the
onboard LAN. The next field - “PCIPME Power Up Control” must
also be set to Enabled.
PCIPME Power Up Control
This field must be set to Enabled only if your PCI card such as LAN
card or modem card uses the PCI PME (Power Management Event)
signal to remotely wake up the PC . Refer to the card’s
documentation for more information.
If you are using the Wake-On-LAN function of the onboard LAN,
you must also set this field to Enabled.
USB Resume From S3
This field, when enabled, allows you to use a USB device to wake up
the system from the S3 state.
PS2KB Wakeup from S3/S4/S5
This field allows you to use the PS/2 keyboard to wake up the
system from the S3/S4/S5 state.
Disable
Disables the PS/2 keyboard wake up function.
Any Key
Use any keyboard keys to wake up the system.
Hot Keys
Use any of the function keys, between F1 and F12,
to wake up the system.
Password
To use a password to wake up the system, select
this option then press <Enter>. Enter your
password. You can enter up to 5 characters. Type in
exactly the same password to confirm, then press
<Enter>.
Important:
If you forgot the password, you must power-off
the system, unplug the power cord and clear
the CMOS data. Follow the steps in the
“Jumper Settings for Clearing CMOS Data”
section in chapter 2.
