www.dfi.com
Chapter 2
- Hardware Installation
KD171
14
►
Jumper Settings
Clear CMOS
JP1
J1
If any anomaly of the followings is encountered —
a) CMOS data is corrupted;
b) you forgot the supervisor or user password;
c) failure to start the system due to BIOS mis-configuration
— it is suggested that the system be reconfigured with default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Put a jumper cap on JP9’s pin 2 and pin 3. Wait for a few seconds and set JP9 back to
its default setting, i.e. jumper cap on pin 1 and pin 2.
3. Plug the power cord and power-on the system.
The 2-pin jack J1 is used to enable or disable Management Engine (ME). Put on a jumper cap
to disable ME (default), or remove the jumper to enable ME.
ME Disable
▲
2-3 On: Clear CMOS
▲
1-2 On: Normal (default)
1
1
3
3
2
2