Energy Star Compliant System Board
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the cord is
correctly and firmly installed in the bus. Be sure the
correct hard drive type is selected in Setup. Also, check
to see if any jumper needs to be set correctly on the
hard drive.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR
PRESENT
Cannot find or initialize the floppy drive controller.
Make sure the controller is installed correctly and
firmly. If there are no floppy drives installed, be sure the
Diskette Drive selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard
is attached correctly and no keys are being pressed
during the boot.
If you are purposely configurating the system without a
keyboard, set the error halt condition in Setup to HALT
ON ALL, BUT KEYBOARD. This will cause the BIOS
to ignore the missing keyboard and continue the boot.
MEMORY ADDRESS ERROR AT...
Indicates a memory address error at a specific location.
You can use this location along with the memory map
for your system to find and replace the bad memory
chips.
MEMORY PARITY ERROR AT...
Indicates a memory parity error at a specific location.
You can use this location along with the memory map
for your system to find and replace the bad memory
chips.
B-3
u
Appendix B
