23
User's Manual |
CS631
Chapter 2
HARDWARE INSTALLATION
Power Connector
X
Internal I/O Connectors
Use a power supply that complies with the ATX12V Power Supply Design Guide Version 1.1. An
ATX12V power supply unit has a standard 24-pin ATX main power connector that must be in-
serted into the 24-pin connector. The 8-pin +12V power connector enables the delivery of more
+12VDC current to the processor’s Voltage Regulator Module (VRM).
The power connectors from the power supply unit are designed to fit the 24-pin and 8-pin con-
nectors in only one orientation. Make sure to find the proper orientation before plugging the
connectors.
The system board requires a minimum of 300 Watt power supply to operate. Your system con-
figuration (CPU power, amount of memory, add-in cards, peripherals, etc.) may exceed the mini-
mum power requirement. To ensure that adequate power is provided, we strongly recommend
that the system is supplied with a minimum of 400 Watt power.
ATX 24-pin Power
Connector
ATX 8-pin Power
Connector
1
4
5
8
+3.3V
+3.3V
GND
+5V
GND
+5V
GND
PWR_OK
+5VSB
+12V
+12V
+3.3V
+3.3V
-12V
GND
PS_ON#
GND
GND
GND
NC
+5V
+5V
+5V
GND
1 13
12 24
GND
+12V
Important:
Insufficient power supplied to the system may result in instability or malfunction
of the add-in boards and peripherals. Calculating the system’s approximate power
usage is important to ensure that the power supply meets the system’s consump-
tion requirements.
The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system’s power is on and a chassis
intrusion occurred, an alarm will sound. When the system’s power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
1
Chassis Intrusion
Chassis Intrusion
X
Internal I/O Connectors
Pin Assignment
Pin Assignment
1
Signal
2
GND
Chassis Intrusion Pin Assignment
